Product SKUs

MBD-PDSM4-O
PDSM4 (Standard Retail Pack)
MBD-PDSM4-B
PDSM4 (Bulk Pack)

Physical Stats

Form Factor
ATX
Dimensions
12" x 9.6", (30.5cm x 24.4 cm)

Processor/Cache

CPU
Single LGA775 ZIF Socket
Supports an Intel® Pentium® D (Smithfield Dual Core) processor
Supports an Intel® Pentium® Extreme Edition processor
Supports an Intel® Pentium® 4 (Prescott) processor
Supports an Intel® Pentium® 4 Extreme Edition processor
Supports an Intel® Celeron® D processor with 256KB L2 Cache
Hyper-Threading (HT) capable
2MB / 1MB L2 Cache
Will not support E2000 processors
System Bus
1066 / 800 / 533 MHz system bus

System Memory

Memory Capacity
Four 240-pin DIMM sockets
Supports up to 8 GB of unbuffered, ECC / non-ECC DDR2 667/533/400MHz memory (Single / Dual Channel)
Memory Type
DDR2 667/533/400MHz unbuffered, ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs
DIMM Sizes
256 MB, 512 MB, 1 GB, 2GB*
Memory Voltage
1.8V only

On-Board Devices

Chipset
Intel E7230 (Mukilteo) chipset
ICH7R + PXH + Intel® 82573V
Serial ATA
Intel® ICH7R SATA2 (3 Gbps) controller built-in
Intel:
RAID 0, 1, 5, 10 support (Windows Only)
Adaptec:
RAID 0 (Two, three, four drives only)
RAID 1 (Two hard drives only)
SCSI
Adaptec AIC-7901
HostRAID 0, 1, 10 Supported
SCSI ZCR
Support for Zero-Channel RAID
Optional: (Card NOT included)
IPMI
2U, 3U, 4U support for Intelligent Platform Management Interface v.2.0, Low Profile (Optional: AOC-LPIPMI-LANG)
RMM (Remote Management Module)
(Card not included)
3rd LAN Optional
Network Controllers
1x Intel® 82573V Gigabit PCI-Express Ethernet
1x Intel® 82573L Gigabit PCI-Express Ethernet
Supports 10BASE-T, 100BASE-T, 1000BASE-T, RJ45 output
VGA
On-board ATI Rage XL (8MB) graphics
Super I/O
Winbond 83627EHF chip
Clock Generator
CK410

Input / Output

Serial ATA
Four Serial ATA ports (3 Gbps performance)
Four SATA hard drives supported
SCSI
U320 Single Channel SCSI
Adaptec AIC-7901
IDE
One EIDE channel supports up to two UDMA IDE devices
Supports UDMA Mode 5, PIO Mode 4, and ATA/100
Floppy
1 Floppy controller; 1.44 MB
LAN
2x RJ45 LAN ports
USB
6x USB 2.0 compliant / 1.1 compatible
2 rear ports, 4 internal headers
2 in front (FUCI), 2 in rear
VGA
1x VGA port
Keyboard / Mouse
PS/2 keyboard and mouse ports
Serial Ports
1x Fast UART 16550 serial port
1x header
Parallel Port
1x ECP / EEP Parallel Header

Chassis ( Optimized for PDSM4 )

2U
SC823S-R500LP
SC823S-550LP
SC822S-R400LP
Tower / 4U Rackmount
SC743S1-645
SC743S1-650
SC743S1-R760
SC742S-450
SC742S-500
SC742S-600
Important Note
For a general system, a 350W (minimum) ATX12V power supply [8-pin +12V AND 24-pin is recommended to assure system stability].

Expansion Slots

PCI-Express
1 (x4) PCI-e slot
PCI - X
2x 64-bit 133MHz PCI-X (3.3V) slots
2x 64-bit 100MHz PCI-X (3.3V) slots

System BIOS

BIOS Type
8Mb Flash EEPROM with Phoenix BIOS®
BIOS Features
Plug and Play (PnP)
DMI 2.3 support
PCI 2.2
ACPI 1.0
Hardware BIOS Virus protection
SMBIOS 2.3
USB Keyboard support
PCI-X - 1.0

Management

Software
Optional IPMI (Intelligent Platform Management Interface) 2.0
SuperDoctor® III
Watch Dog
NMI
Power Configurations
ACPI/APM Power Management
Main Switch Override Mechanism
Wake-On-Ring (WOR) header
Wake-On-LAN (WOL) header
Keyboard Wakeup from Soft-Off
CPU Fan auto-off in sleep mode
Power-on mode control for AC power loss recovery
Internal/External modem remote ring-on

PC Health Monitoring

Voltage
Monitors for CPU Cores (+1.8V, +3.3V, +5, ±12V, +5V Standby)
CPU Core 4-Phase-switching voltage regulator with auto-sense from 0.8375V-1.6000V
Adjustable CPU clock frequency ratio settings (via BIOS)
FAN
Total of five 4-pin fan headers
5x fans with tachometer monitoring
Status monitor with firmware / software speed control
Status monitor for on/off control
Support 3-pin fans (with speed control)
Low noise fan speed control
Pulse Width Modulated (PWM) fan connector
Temperature
Monitoring for CPU and chassis environment
CPU Thermal Trip support
Thermal Monitor (TM2) Support
LED
CPU / System Overheat LED
+5V standby alert LED
Suspend-state indicator LED
Other Features
Chassis intrusion detection
Chassis intrusion header

Operating Environment
Environmental Spec.
Operating Temperature: 10°to 35°C (50°to 95°F)
Non-operating Temperature: -40°to 70°C (-40°to 158°F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing)

OS Compatibility

• Please see our OS Compatibility Chart

Regulatory

FCC
Passed to meet FCC standard requirement

További specifikáció